ColorMFA Torque view from EDC15

[Tiavoq]

Hi Guys,
It is about the torque display in the ColorMFA after a CHIP TUNING and new nozzles etc. the torque display is no higher than series.
Does anyone know how to change it in the EDC15? No tuner with me knows anything about it. Maybe someone knows the map address or something else where you can change it.
I hope someone can help me.

Car: Golf 4 1.9 TDI AXR 101PD EDC15P

Yours sincerely

[autopilot]

In what place torque display incorrectly ?
Measured values (main screen, graph, gauges, e.t.c.) or in MotorInfo screen ?

[Tiavoq]

My car has a series of 240 nm and it has been chipped to over 300 nm but it is only displayed in the ColorMFA maximum of 260 nm on the main screen or in the measurement.
I do not think that it is a mistake from the ColorMFA but that it was not made in the EDC15 control unit, so I want to do it and ask if someone knows the address from the map to change it so that the ColorMFA gets the correct information about Can.

[autopilot]

I can not help you in this situation...
I don’t know anything about motor firmware.

You (or your chiptuning developper) may read this file: https://www.google.ru/search?q=EDC15+Fu ... schreibung
Maybe you find some info.
ColorMFA use ID 280, byte2 (inner motor torque) and byte7 (mechanical loss of torque) to calculate real torque value.
Also use ID 288, byte1 (MDNORM) for scale torque value.

[Tiavoq]

Yes No problem.
Thank you for the information I look and listen to something if I find something.
Maybe someone in the forum knows what about changing the EDC15 for ColorMFA torque.
At other EDC forums they don't know ColorMFA.

[autopilot]

These changes are not "only for ColorMFA." These are typical values ​​and tuners should be aware of this.
On some engines (mainly petrol engines) this value is also shown in the diagnostics. And if you do not correct it in the engine control unit (when setting up the firmware), it will also show the wrong value in the diagnostic mode (VCDS or any other test adapters).

[Tiavoq]

Okay but somehow no tuner can set it to me correctly. Nobody knows anything about it, so I'm looking for where I can set it myself in the map