не отображается для отображения boost

Pig Lien · Сообщение 02 апр 2019, 08:28

VW BORA 2004 1.8T года, из версии прошивки b5_flash_v2.9.4b26 не отображается для отображения boost, но версия прошивки b5_flash_v2.9.4b25 может отображать boost, может решить эту проблему?

Сообщение 02 апр 2019, 09:39

Не совсем понятна проблема.
Обновитесь до текущей актуальной версии. Возможно ваша проблема уже исправлена.

maxi987 · Сообщение 02 апр 2019, 16:59

I had the same problem, without seperate connection boost showed till b25, since b26 there is an extra connection needed...

Сообщение 02 апр 2019, 23:18

What car ? What engine ?

maxi987 · Сообщение 03 апр 2019, 00:45

Golf 4 1.8T, Engine: AUM, 2002

Сообщение 03 апр 2019, 00:51

On this engine, boost show only via external connection.
Boost on CAN is not present.

maxi987 · Сообщение 04 апр 2019, 22:20

But it worked till b25, i had not an external connection. I just added it after the b26 update...

Сообщение 05 апр 2019, 03:46

maxi987 писал(а): ↑
04 апр 2019, 22:20
But it worked till b25, i had not an external connection. I just added it after the b26 update...

I think is show incorrect value.
Take photo of CAN-Monitor with active only Motor-CAN. On running engine. Data on screen can scroll, need take photo of all data.

maxi987 · Сообщение 05 апр 2019, 20:48

autopilot писал(а): ↑
05 апр 2019, 03:46

maxi987 писал(а): ↑
04 апр 2019, 22:20
But it worked till b25, i had not an external connection. I just added it after the b26 update...
I think is show incorrect value.
Take photo of CAN-Monitor with active only Motor-CAN. On running engine. Data on screen can scroll, need take photo of all data.

Visually no difference between both values, with external conmection and without. Tomorrow ill take photos of can bus

Сообщение 06 апр 2019, 02:08

If boost is really present on CAN, I'll enable this function... Did you make any changes to the engine firmware to display additional parameters ?
I have seen boost on CAN only on T5 and last A4B7 (with "big" engines like 3.0TDI).
On all other cars, value on CAN is empty or wrong...

P.S. I mean cars on which it is possible to install ColorMFA...

maxi987 · Сообщение 06 апр 2019, 18:00

I changed the ecu firmware before installing colormfa, but not added additional parameters to be present on can bus

Сообщение 06 апр 2019, 18:21

Yes, boost is present on CAN.
I'll enable in next update selection CAN as boost source for all cars if boost on CAN is present.